Network card recognised but won't connect internet?

[cliff]

These are extracts of my system , so close but will not connect to my ADSL router .
Seems it sees the NIC but can't bring it up or something,(skc0: no PHY found!)?
Also can't see it if I do a /stand/sysinstall
Any help greatly appreciated.
Cliff


dmesg
*****
skc0: <Marvell Gigabit Ethernet> port 0xa800-0xa8ff mem 0xf5000000-0xf5003fff irq 20 at device 9.0 on pci2
skc0: Marvell Yukon Lite Gigabit Ethernet rev. (0x9)
sk0: <Marvell Semiconductor, Inc. Yukon> on skc0
sk0: Ethernet address: 00:0f:ea:71:f7:86
skc0: no PHY found!


pciconf -lv
***********
skc0@pci2:9:0: class=0x020000 card=0xe0001458 chip=0x432011ab rev=0x13 hdr=0x00
vendor = 'Marvell Semiconductor (Was: Galileo Technology Ltd)'
device = '88E8001 Gigabit 32-bit Ethernet Controller with Integrated PHY'
class = network
subclass = ethernet


rc.conf
*******
#background_dhclient="YES"
#hostname="PCBSD.localhost"

#NIC="de em ixgb txp vx bfe bge dc fxp lge nge pcn re rl sf sis sk ste ti tl tx vge vr wb xl cs ed ex ep fe ie lnc sn xe an awi wi"

NIC="sk"

ifconfig_sk0="inet 10.0.0.1 netmask 255.255.255.0"
defaultrouter="10.0.0.138"

#for i in $NIC; do
# eval ifconfig_${i}0="DHCP"
# eval ifconfig_${i}1="DHCP"
#done
blanktime="180"
saver="logo"
sshd_enable="YES"
usbd_enable="YES"
moused_type="auto"
moused_enable="YES"
samba_enable="YES"
lpd_enable="YES"


resolv.conf
***********
search lan
nameserver 10.0.0.138

[Valio]

Take a look in here:

http://lists.freebsd.org/pipermail/free ... 06534.html



I'll hope that helps

[cliff]

Thanks for the reply , I think that need compiling and maybe to redo kernal perhaps not quite
up to it yet. Maybe the next release will work.

rgds,
Cliff

[Bodyweb]

I have the same problem to connect me to the LAN and no idea at all on what to do
I'll have a look to this nice guide : http://www.bsdguides.org/guides/freebsd ... etwork.php

[Bodyweb]

My problem is that in the ifconfig -a the answer is :

media: Ethernet autoselect (none)
status: no carrier

Someone told me that the kernel may not recognize the ethernet card so I should compile again the kernel with the correct driver for that specific card.