Dialog frozen after portsnap.

[krreagan]

I have 1.2 installed and went tou pdate my ports in the control panel. everything seemed to work ok until it was finished... The two progress indicators were pegged at 100% and it said Finished. when I clicked on the "finished" button, nothing happened. The window close button also did nothing. I had to close the control panel app for the dialog window to go away.

Let me know if there is anything else needed to debug this.

Krreagan

[antik]

I have 1.2 installed and went tou pdate my ports in the control panel. everything seemed to work ok until it was finished... The two progress indicators were pegged at 100% and it said Finished. when I clicked on the "finished" button, nothing happened. The window close button also did nothing. I had to close the control panel app for the dialog window to go away.

Let me know if there is anything else needed to debug this.

Krreagan

From command line fire:

# portsnap update

if it works fine, then there is no problems. But it strange that is freezed for so long- something to do with filesystem maybe?

You can debug with ktrace.

[dracheflieger]

I have 1.2 installed and went tou pdate my ports in the control panel. everything seemed to work ok until it was finished... The two progress indicators were pegged at 100% and it said Finished. when I clicked on the "finished" button, nothing happened. The window close button also did nothing. I had to close the control panel app for the dialog window to go away.

Let me know if there is anything else needed to debug this.

Krreagan

I meant to mention this earlier today, using the KMenu|Settings|System Administration|PC-BSD System and doing the portsnap there the first time after my PBI update from 1.11a to 1.2 resulted in two portsnap progress meters. It works fine now except that the progress window always popup under the System window and will not close until you close the System window.