PDA

View Full Version : PCBSD 0.8 not working after installation


franzxmaier
09-17-2005, 01:16 PM
I tried to install PCBSD 0.8 several times (with different options), but it doesn't work: installation goes ok, but at first boot the display gets flooded with unreadable lines of text flushing over the screen. I stopped after 10 minutes (no change).
Note: I tried to change the disk-mode to pure LBA, as I found this hint in this forum - same error.
Note: PCBSD is the only OS on the PC, installation uses whole disk.

Please help!

Regards

Franz X. Maier :?:

Marcin
09-18-2005, 10:38 AM
Hi

I disable APIC mode in my bios , and start PCBSD with acpi=off .

Warning : if You have a windows in Your hdd , enable APIC if you want start windows. You dont have disable APIC if You install windows with disable APIC mode.

Try.

Bye

franzxmaier
09-18-2005, 11:31 AM
Thank you. I tried, but it didn't help.

Regards

Franz X. Maier